Interfaces:

• AC Input
• Universal AC input 110/220VAC
• DC+ETH Output
• 3 ports, Per Port:
• 48VDC, 215W
• ETH, CAT5, 100m
• Local Management
• ETH, (internal only-after opening the door)

AC Input:

• Voltage
• 90-264Vac, single phase
• Frequency
• 47-63Hz
• Inrush Current
• ≤ full load steady state current of the rectifier within rated limits
• Efficiency
• 90% typical at 120Vac, full load rated power (650W)
• AC input current
• 3.0 to 3.5A (nominal Vac)
• 4.9A maximum @150Vac
• Power Factor
• >0.99 at nominal conditions and 50-100% load;
• >0.98 at nominal conditions and 30-50% load
• Input Protection
• A 250Vac FAST ACTION Circuit Breaker

Mechanical:

• Size [WxHxD]
• 55x52x52 cm
• Weight
• 35 Kg
• Input AC Connector
• Terminal block
• DC Output Connector
• Terminal block
• Network Connector
• RJ45

Management:

• Management
• Internet: Web-based management
• Interfaces: Telnet, SNMP, Web, Remote
• SNMP
• SNMP Client MIBs:
• MIB II, Private MIB
• Remote Configuration
• Auto Configuration: DHCP
• SW Download: via TFTP
• PS Fault Alarms
• Power Supply
• DC output
• Battery low voltage
• Additional Alarms
• TBD

Environmental:

• Temperature
• Operating: -40°C to +46°C + Solar radiation
• Storage: -40°C to +85°C
• Cold Start Temperature
• -40°C
• Temperature Coefficient
• ≤100ppm/°C over the operating range
• Humidity
• Maximum 5% to 95% RH
  non-condensation
• Altitude
• Operating -1640 to 9840 ft
• Non-operating 40,000 ft
• Vibration
• Zone 4 requirements
• Cooling
• two cooling fans
• Water Tightness
• NEMA Type 3R

DC Output:

• Power
• 42-58VDC, 2 x 650W (3 Sectors BST)
• Load
• Max: 2x12A
• Peak: 2x13.5A
• Line Regulation
• Static <±0.1%
  
• Dynamic <±1% for any change within rated limits
• Load Regulation
• Static <±0.5%
  
• Dynamic <±1% for 40 to 90% load step 2ms recovery time
• Turn On Delay
• 5 sec. Maximum
  (excluding soft start)
• Hold-up Time
• 10msec minimum at 110Vac and full load
• Turn-On Rise Time
• 105 to 120% of IMax, constant current limit, automatic recovery, when cause of overload or short is removed
• Over-current Protection
• 105 to 120% of IMax, constant current limit, automatic recovery, when cause of overload or short is removed
• Over-voltage Protection
• Shut down at 120 ÷ 125% of nominal output, AC input must be recycled to restart
• Temperature Protection
• Shutdown due to excessive ambient temperature at over heating or malfunctions of cooling fans. The sense point is at 90°C for the internal heat signal, unit recovers automatically typical hysterisis 20°C
• Current Share
• The unit works with similar units to form a redundant power module configuration. A single wire load share mechanism is used between similar units
• Hot Swap
• Internal O-Ring diode (FET)

Battery Compatibility

• Voltage
• 12V (one string 48VDC)
• Number
• 4
• Type
• Gelled Electrolyte
• Capacity
• 44Ah (optional 33Ah, 26Ah)

Safety & EMC Regulations:

• EMC
• FCC class B, EN55022 CLASS B
• Safety
• CSA C22.2 No 60950-1-03
• UL 60950-1
• IEC/EN 60950-1
• CE – MARK
• EN61000-3-2
• HARMONICS
• EN61000-3-3
• Voltage Fluctuation
• EN6000-4-2
• ESD +8KV AIR +4KV CONTACT DISCHARGE, performance criteria B
• EN61000-4-3
• Radiated Immunity: 80-1000Mhz 3V/m, AM 80% (1KHz), criteria A
• EN61000-4-4
• Fast Transient: 1KV for AC power port, 0.5KV for DC power I/O and signals Port, performance criteria B
• Capacity
• Surge: 2KV common mode and 1KV differential mode
• EN61000-4-6
• 3VRMS, 80% A.M. BY 1kHz
• EN61000-4-11
• Voltage Dips and interruption: 30% reduction for 10mSec –Criteria B, 60% For 100mSec. Criteria C, 95% reduction for 5000mSec Criteria C
• Dielectric Withstand
• Input to case: 1500VAC.
• Input to output: 3000VAC
• Output to case: 2100VDC
• Leakage Current:
• <3.5mA @ 265Vac 60Hz
• MTBF
• 200,000 hours minimum per BELCOR 332, issue 6 specification @ 30°C